4D product information for
GPIO 26way (2x13) Pin Pass-Through Header
- Product Title: GPIO 26way (2x13) Pin Pass-Through Header
- Manufacturer/Publisher: Various
- Stock Code: VAR-2X13M-PT
- QuickCode: 17226
- Format: Hardware
- Product Group: Raspberry Pi: GPIO, RTC & Sensors
- Condition: New
- Availability: Usually available from stock
2x13way pin header, Pass Through. The pins are about 10mm long to allow a pass-thru connection after soldering to a pcb (eg. RTC).
Please note that whilst cheaper connectors are available, we bought a cheap one only to find that the pins are rather thin (0.53mm square). Most pins are 0.64mm square (like the GPIO pins on a Raspberry Pi)
We found that a GPIO cable almost falls off the 0.53mm pins if turned upside down.
It would make a very unreliable connection.
Our connector uses 0.64mm square pins that are approximately 10mm long with a total connector length of approximately 23mm.
n.b. If you were soldering to the pins then the thinner pins would be fine but we expect many if not most people to plugging in connectors (Hats etc.) or cables in which case full size pins are essential for good contact.
- Price: £5.50 no VAT to pay!
- Free UK delivery on orders of £10 or more! (exceptions apply)
Selling to the Acorn/RISC OS market for over 30 years!
Most orders of less than £10 will incur a £3 admin charge.
Items on special offer are while stocks last and may be time limited.
Items marked S/H are secondhand and have a 3 month warranty
Unless otherwise stated, photos are for illustrative purposes only
UK delivery included on orders of £10 or more (exceptions apply), please ask for overseas delivery cost.
Please check for compatibility. Official orders welcome. E&OE
If you have a sales enquiry please email our sales department
78 Brighton Road, Worthing, West Sussex, BN11 2EN, UK. 01903 523222 (full contact details)
If you have any comments or problems please email firstname.lastname@example.org
CJE Micro’s is not responsible for the contents of external internet sites.
Last updated: Sat, 14 Apr 2018